Announcements

EIT Certificate Reminder:

In accordance with section 4.2 of Engineer Land Surveyor and Geologist Registration Law, 63 P.S. § 151.2, an applicant cannot begin accruing four or more years of progressive experience to qualify for the principles and practice of engineering examination until AFTER the engineer-in training certificate (EIT) is issued.

It is the responsibility of the applicant to apply for the EIT. Applicants must show satisfactory evidence of graduation from an approved engineering curriculum of four or more years or eight years of progressive experience approximating the education obtained through an approved engineering curriculum, to obtain the EIT. The date of issuance of the EIT will be the date the completed EIT application – including proof of graduation when applicable – is processed.

§ 37.58. Seal.

(a) A registrant shall obtain, at the registrant’s own expense, a seal in the design authorized by the Board. The following are Board authorized seals for ‘‘Registered Professional Engineer’’ (Design A), ‘‘Registered Professional Land Surveyor’’ (Design B) and ‘‘Registered Professional Geologist’’ (Design C):
(b) The seal shall contain the legend ‘‘Registered Professional Engineer,’’ ‘‘Registered Professional Land Surveyor’’ or ‘‘Registered Professional Geologist’’ and the registrant’s name and registration number.
(c) The seal shall be 1 3/4 inch in diameter. The diameter of a pocket seal may be reduced to 1 1/2 inch if the design is in the same relative proportions in subsection (a).
(d) A registrant may use a rubber stamp or computer image which is a facsimile of the seal, if the registrant first obtains a seal in accordance with this section.

Your seal may be obtained from any seal manufacturer (Search 'Seals-Notary & Corporation')

Any questions regarding your license should be directed to the Board office. Address changes must be reported in writing within ten days following the change.